Asus X99-DELUXE II SERIES - Page 59

ASUS X99-DELUXE II Series BIOS Manual
59
The following items appear only when you set the Water Pump Control to [Auto], [DC
mode] or [PWM mode].
Water Pump Temperature
Use the <+> and <-> keys to adjust the upper limit of the water pump.
The values range from 45°C to 75°C. The water pump will operate at the
maximum duty cycle when the CPU temperature is higher than the limit.
Water Pump Max. Duty Cycle(%)
Use the <+> and <-> keys to adjust the maximum water pump duty cycle.
The values range from 60% to 100%. When the CPU temperature reaches
the upper limit, the water pump will operate at the maximum duty cycle.
Water Pump Middle Temperature
Use the <+> and <-> keys to adjust the water pump middle temperature.
The values range from 40°C to 75°C.
Water Pump Middle Duty Cycle(%)
Use the <+> or <-> keys to adjust the water pump middle duty cycle. The
values range from 60% to 100%.
Water Pump Lower Temperature
Use the <+> or <-> keys to adjust the lower limit of the water pump
temperature. The values range from 20°C to 75°C. The water pump will
operate at the minimum duty cycle when the CPU temperature is lower
than the limit.
Water Pump Min. Duty Cycle(%)
Use the <+> and <-> keys to adjust the minimum water pump duty cycle.
The values range from 60% to 100%. When the CPU temperature is lower
than the lower limit, the water pump will operate at the minimum duty cycle.
HAMP Fan Control
This item allows you to set the HAMP Fan operating mode.
[Auto] Detects the type of HAMP Fan installed and automatically switches the
control modes.
[PWM Mode] Enables the HAMP Fan Control feature in PWM mode for 4-pin HAMP
Fan.
[DC Mode] Enables the HAMP Fan Control feature in DC mode for 3-pin HAMP Fan.
[Disabled] Disables the HAMP Fan Control.
HAMP Fan Q-Fan Source
The assignment fan will be controlled according to the selected temperature source.
Conguration options: [CPU] [MotherBoard] [PCIEX16_1 Slot] [PCIEX16_3 Slot]
[VRM] [PCH] [T_SENSOR1] [EXT_Sensor1] [EXT_Sensor2] [EXT_Sensor3] [Multiple
Sources]
• For EXT_Sensor1-3, connect a Thermistor cable to the EXT_TS1-3 header then place
the other end to the component to get the temperature.
• For Multiple Sources, select up to three temperature sources and the fan will
automatically change based on the highest temperature.