Asus Z7S WS - Page 27

ASUS Z7S WS 2-5
6. Before installing the motherboard
into the chassis, locate the standoffs
that should match the eight (8) CEK
spring screw holes.
8. Secure the motherboard with eight (8) screws. Refer to section
2.2.2 Screw
holes
for illustration.
Make sure that the standoffs perfectly match the CEK spring screw holes;
otherwise, you can not install the CPU heatsinks properly.
Standoffs for CPU0
Standoffs for CPU1
7. Install the motherboard with the
external I/O ports toward the chassis
rear panel. The CPU sockets should
be right on top of their respective
standoffs.
Socket for CPU1
Socket for CPU0