Asus Z7S WS - Page 56

2-34 Chapter 2: Hardware information
4. USB connectors (4-pin USB6, 10-1 pin USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to
these connectors, then install the module to a slot opening at the back of the
system chassis. This USB connector complies with USB 2.0 specication that
supports up to 480 Mbps connection speed.
The USB port module is purchased separately.
USB+5V USB_P8- USB_P8+ GND NC
USB+5V
USB_P7-
USB_P7+
GND
Z7S WS USB connectors
USB78
USB6
Z7S WS
®
You can connect the USB cable to ASUS Q-Connector (USB, blue) rst, and
then install the Q-Connector (USB) to the USB connector onboard.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!