ZenWiFi
Wireless AC3000 Tri Band Gigabit Router
Model: CT8
Quick
Start Guide
1
Plug the adapter into the DCIN port, and press the Power On/Off.
2
The power LED will light up when your hardware is ready.
Hardware Explanations
Button and Port Explanations
WAN port
Connect your modem to this port
with a network cable.
LAN ports 1-3
Connect your PC to a LAN port with
a network cable.
Before Setup
ASUS Router App
AiMesh Setup Steps
Troubleshooting
1
Find two ZenWiFi CT8, and power both on.
2
Use a network cable to connect your modem to the WAN port of either ZenWiFi CT8. This
ZenWiFi CT8 will be the AiMesh router, and the other ZenWiFi CT8 will be the AiMesh node.
3
The LED turns solid blue to indicate that ZenWiFi CT8 is ready for setup.
Preparing to set up an AiMesh Wi-Fi system
AiMesh Setup Steps
AiMesh routerAiMesh node
Download free ASUS Router APP to set up
and manage your router(s).
AiMesh routerAiMesh node
within
1-3 meters
Prepare
01
Place your AiMesh router and node within 1-3 meters of each
other during the setup process.
AiMesh node
02
Load factory defaults. Keep your router powered on and stand-
by for AiMesh system settings.
Enable Bluetooth on your phone. Launch ASUS Router APP, and then follow the on-screen in-
structions to finish the AiMesh setup.
Enabling Bluetooth Launching ASUS Router APP
03 04
If your AiMesh router cannot find any AiMesh node nearby or
synchronization fails, please check the following and try again.
a
Move your AiMesh node closer to the AiMesh router ideally. Ensure that it is
within 1-3 meters.
b
Your AiMesh node is powered on.
DC Power adapter DC Output: +19V with max 1.75A current
Operating Temperature 0~40
o
C Storage 0~70
o
C
Operating Humidity 50~90% Storage 20~90%
Specications:
Power On/OffDC-IN port
WAN port
LAN ports 1-3
USB 3.0/2.0 port
To Next Page
Need help?
General
