18
Fuel Filter Change
The fuel filter should be changed every
500 service hours, or as needed. A
plugged fuel filter can cause loss of
engine power, rough running, or no start.
To change the filter:
1. Clean the outside of the filter (1) thor-
oughly (shown above).
2. Remove bolt (2) on the top of the fil-
ter assembly, then remove filter.
3. Pour diesel fuel into new filter until it
is full.
4. Reverse step 2 to install the new fuel
filter into the machine.
Fuel Specifications
In North America, diesel fuel, distilled
from crude oil, that is identified as No. 1-
D or No. 2-D in "ASTM D975" generally
meet the proper specifications.
Item Frequency Lubricant Capacity
Hydraulic fluid 500 hours ASV Premium 8 gal./30 L
MV Hydraulic Oil or
similar like Amoco Rykon MV
Hydraulic filter 250 hours
Engine oil 500 hours See p. 16 PT-30 - 1.6 gal./6.06 L
Engine Oil filter 500 hours
Fuel filter 500 hours
Coolant additive Test at 250 hours
Coolant change 1,000 hours or 2 years PT-30 - 1.5 gal
Primary air filter Check daily, clean or replace as needed (see page 22)
Secondary air filter Replace after every 3 cleanings of primary filter
All grease fittings Daily (prior to operation) ASV MP Lithium Grease
Track tension As needed (see page 20)
Note: When adding or replacing engine coolant, use ASV Long-Life Anti-Freeze/Coolant or similar
with proper SCA (supplemental cooling additive).
MMAACCHHIINNEE MMAAIINNTTEENNAANNCCEE
2
1
A
To Next Page
Loading...