To Next PageTo Next Page
Need help?Do you have a question about the ASV ST50 Scout and is the answer not in the manual?
General| Brand | ASV |
|---|---|
| Model | ST50 Scout |
| Category | Utility Vehicle |
| Language | English |
Explains terms like front, rear, left, and right from the operator's perspective.
Explains the meaning of safety symbols and warning levels (Danger, Warning, Caution).
Details the location of the Product ID (PIN) and Engine Serial Number for reference.
Details safety features like seat belts and presence switches for operator protection.
Specifies the machine's cargo bed capacity and Gross Vehicle Weight (GVW) limits.
Guidelines to prevent fires by managing heat sources and flammable materials.
Illustrates the placement of various warning decals on the machine for hazard awareness.
Explains key warning decals related to operation, pre-start checks, and ROPS protection.
Details warning decals concerning load safety, capacity, and passenger restrictions.
Procedures for safely installing and removing the dump box brace for maintenance.
Identifies and explains the various switches and instruments on the control panel.
Details the operation of the bi-directional speed control pedal and steering wheel.
Explains the engine throttle control and the two-speed hydrostatic drive system.
Describes intermittent flow auxiliary hydraulic system operation.
Explains the operation of the continuous flow auxiliary hydraulic system.
Outlines the essential safety checks to perform before operating the machine.
Step-by-step guide for starting the ST-50 engine safely and correctly.
General guidance on operating the machine, including practice in an open area.
Covers stopping, turning, hill side operation, and operating on turf.
Safety guidelines for loading and carrying materials in the cargo bed to ensure stability.
Crucial safety precautions and general warnings to follow during maintenance procedures.
Instructions for safely jacking and supporting the machine for maintenance.
A schedule outlining required maintenance tasks and their intervals.
Procedures for cleaning the radiator, oil cooler, and engine compartment for optimal performance.
Procedures for inspecting and servicing the air cleaner elements.
Procedures for cleaning air filter elements and replacing the fuel filter.
Step-by-step guide for starting, draining oil, and removing the oil filter.
Completes the oil change by installing the new filter, filling oil, and checking for leaks.
Instructions on how to properly check the engine oil level and viscosity grades.
Maintenance tasks for the water separator, accessory belts, and fuse panel.
Procedures for changing hydraulic fluid and replacing the hydraulic filter.
Guidelines for cleaning and inspecting the undercarriage assemblies.
Instructions for lubricating grease fittings and adjusting track tension on the undercarriage.
Detailed procedures for removing the rubber tracks from the undercarriage.
Continues the detailed procedures for removing the rubber tracks from the undercarriage.
Completes the detailed procedures for removing the rubber tracks from the undercarriage.
Detailed procedures for installing the rubber tracks onto the undercarriage.
Completes the detailed procedures for installing the rubber tracks onto the undercarriage.
Steps for inspecting and replacing drive sprocket rollers on the undercarriage.
Completes the inspection and replacement of drive sprocket rollers.
General troubleshooting overview and common causes for the machine not starting.
Troubleshooting common issues related to hydraulics, electrical system, and overheating.
