To Next PageTo Next Page
Need help?Do you have a question about the ATA Saphir 330 and is the answer not in the manual?
Check for damages and completeness after unpacking Saphir 330.
Place Saphir 330 on a flat table and connect power and water.
Machine is ready for operation after water and electrical connection.
Saphir 330 requires minimal maintenance; focus on the collect bowl.
Flush drain regularly to prevent clogging; loosen and remove sediment if needed.
Clean cabinet and front with a damp cloth, avoid abrasive cleaners.
The unit is packed in a box with specified dimensions and approximate weight.
Pay attention to persons or parts of the body when unloading to prevent accidents.
Introduction to the Saphir 330 grinding/polishing machine.
The Saphir 330 features a powerful motor connected via a maintenance-free V-belt.
Explanation of warning signs used on the machine.
Safety is conditional for non-dangerous operation; operator instruction is necessary.
Key safety instructions: operate as instructed, disconnect power before opening.
The grinding/polishing process is operated manually without the Rubin 500 attachment.
Attach a 1/2 inch connection with a compressive tube to the coolant system.
Inspect voltage, protection conductor, and secure connection with 16A.
General