Atag MC3211C - Page 75

GB 15
how to use your oven
setting the display to stand-by mode
To reduce your oven's power consumption to a minimum when it is
not in use, you can put your readout system in STANDBY MODE.
To carry out this operation, proceed as follows:
GOING INT
O STANDBY MODE:
- Your oven must be in normal time readout mode.
- Press both the + and - controls for five seconds at the
same time.
- The display reads "Lcd off".
- Take your fingers off the two controls.
- 30 seconds later your readout will switch off.
Your oven is now in standby mode; whenever you are in the normal
time readout mode, it will turn off automatically after 30
seconds.
COMING O
UT OF STANDBY MODE:
- Your oven must be in the normal time readout mode.
- Press the + and - controls for five seconds at the
same time.
- The display will then read "Lcd on".
- Take your fingers off the two controls.
- You are now out of the STANDBY MODE; the readout is now per-
manently lit.