What to do if my Atag Washer does not fill with water?
If your Atag Washer isn't filling with water, several factors could be the cause. First, ensure the water tap is fully open. Check that the water supply pressure isn't too low by contacting your local water authority. Also, make sure the water tap and the filter in the inlet hose are not clogged. Finally, verify that the inlet hose has no kinks or bends restricting water flow.
Why my Atag Washer won't start the program?
If the program on your Atag Washer isn't starting, there are a couple of things to check. First, make sure that the appliance door is completely closed. Also, if you've set a delay start, either cancel the setting or wait for the countdown to finish.
How to fix Atag Washer that won't drain water?
If your Atag Washer isn't draining water, check to make sure that the sink spigot is not clogged. Also, ensure that the drain hose has no kinks or bends.
What to do if I cannot activate the Atag Washer?
If you're unable to activate your Atag Washer, ensure that the mains plug is properly connected to the mains socket and check the fuse box for any damaged fuses.
What causes wet dishes in Atag Washer?
If your dishes are coming out wet from your Atag Washer, it could be due to several reasons. The wash program may be without a drying phase or have a low-temperature drying phase. Also, the rinse aid dispenser might be empty, or the quality of the rinse aid or combi detergent tablets could be the problem. Consider trying a different brand of detergent.
How to remove stains and dry water drops on glasses from Atag Washer?
To address stains and dry water drops on glasses and dishes from your Atag Washer, try adjusting the rinse aid selector to a higher position. The quality of the detergent can also be the cause.
How to remove whitish streaks from Atag Washer?
To remove whitish streaks or bluish layers on glasses and dishes when using your Atag Washer, adjust the rinse aid selector to a lower position. Also, ensure that you are not using too much detergent.
What to do if the anti-flood device is on in Atag Washer?
Close the water tap and contact the Service.
To Next Page
General