The display shows the updated programme
duration.
ExtraHygiene
With this option you have better hygiene
results. During the last rinsing phase, the
temperature stays at 70 °C for at least 10
minutes.
How to activate ExtraHygiene
Press , the related indicator comes on
If the option is not applicable to the
programme, the related indicator does not
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated programme
duration.
AutoOpen
This option improves the drying results with
less energy consumption.
• While the drying phase operates, a
device opens the appliance door and
keeps it ajar.
• At the end of the programme, the device
and the appliance door retract. The
appliance is automatically deactivated.
CAUTION! Do not try to close
the appliance door while the
device keeps the door ajar. This
can cause damage to the
appliance.
This option is automatically activated when
you select the programme
. The
indicator comes on.
It is not possible to select this option with
other programmes.
If you want to deactivate the option
AutoOpen, press
. The related indicator
goes off. In this condition, the energy
consumption of the programme increases.
BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener. It
seems that the appliance is not working.
The washing phase starts only after this
procedure is completed. The procedure will
be repeated periodically.
12
To Next Page
Loading...
