EasyManua.ls Logo

Atag WS6011MR - Extraction Systems

Atag WS6011MR
90 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB 6
Attention!
First disconnect the appliance from the socket when you replace
the lights!
Only use identical lamps with the wattage indicated. Only use the
cooker hood with lamps installed to reduce the risk of electrical
shock.
The grease filters become hot during operation. Wait a minimum of
30 minutes after cooking before cleaning it.
The main current must be switched off during reparation or
cleaning. Remove the plug from the mains current or turn the switch
in the meter cupboard to zero.
Grease and oil are flammable when they are overheated. Stay in the
vicinity of the cooker when preparing food.
We will not accept any responsibility for any faults, damage or fires
caused to the appliance as a result of the non-observance of the
instructions included in this manual.
Extraction systems
These hoods have two extraction systems working parallel:
1. As an extractor hood on a CMV extraction duct:
The cooking vapours are sucked in and filtered and then carried
outside via the CMV system.
2. Recirculation hood:
As a recirculation hood, the grease particles and the smell in the
extracted vapours are filtered. The air that has been sucked in is
not carried outside but recirculates in the kitchen.
1
2
SAFETY

Table of Contents

Related product manuals