GB 11
• If you want to see the charcoal filter signal the next time you have
to clean the charcoal filter, you have to switch it on again; switch off
the hood by pressing the Off button and press the Off button and
the On button simultaneously for at least five seconds.
The 4 green LEDs light up and the hood gives an audible signal.
The charcoal filter signal will occur the next time you need to clean
the charcoal filter.
• If you do not want to occur the charcoal filter signal any more, you
have switch it off; switch off the hood by pressing the Off button
and press the Off button and the timer button simultaneously for at
least five seconds.
The 4 red LEDs light up and the hood gives an audible signal.
The charcoal filter signal will not occur any more.
• You can check if the charcoal filter signal is switched on by
pressing the light button and the timer button simultaneously for at
least five seconds.
When the charcoal filter signal is switched on, the 4 green LEDs
light up, otherwise the 4 red.
Switching off the button signal
• If you press a button, a signal sounds in confirmation. Press the On
button and the timer button simultaneously for three seconds to
switch off the button signal.
• Repeat this procedure if you wish to switch on the key signal again.
ON
OFF
12h
OFF
12h
ON
12h
OPERATION
To Next Page
Loading...
Need help?
General
