Atag WV9311NM - Changing the Charcoal Filter; Lighting Unit

EN 10
MAINTENANCE
Resetting the alarm signal
• Turn the lights and the motor off, then disable the 24h function,
if enabled.
• Press button E.
Changing the Filter
• Open the glass panel.
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing the fixing hook.
• Fit the new filter and fasten it in its correct position.
• Replace the metal grease filters.
• Close the glass panel.
Lighting unit
Warning: This appliance is fitted with a white LED lamp classed as
1M according to EN 60825-1: 1994 + A1:2002 + A2:2001 standards;
maximum optical power emitted @439nm: 7µW.
Do not look directly at the light through optical devices (binoculars,
magnifying glasses…).
For replacement contact technical support.
I