9
3. Unpacking and Installation
(1) Configuration
The instrument is comprised of the items listed below.
①Main unit and standard accessories.
② through ⑥ are optional items and are included with the main unit if ordered.
Additional items can be ordered at any time. For details, please contact an Authorized
ATAGO Distributor.
① In-line Brix-Monitor CM-800α (Cat.No.3564)
• Main unit
• Power (DC24V) cable: approx. 1m
• O-ring (Silicon)........................ 1
• O-ring (EPDM) ........................ 1
• Instruction manual (this book)
• Inspection certificate
② AC adapter AD-32 (Cat.No. 3527), AD-33 (Cat.No. 3528) or AD-34 (Cat.No. 3529)
The AD-32 is an adapter that converts AC 100V to DC24V for supplying power to the
main unit.
The AD-33 is an adapter that converts AC 110V to DC24V for supplying power to the
main unit.
The AD-34 is an adapter that converts AC 220-240V to DC24V for supplying power to
the main unit.
③ Sample inlet unit
IDF/ISO clamp union (ferrule), IDF/ISO screw union (screw), JIS Flange, small
diameter series compression fitting and hose connector are available. Refer to page
38 "19.Consumable Parts and Optional Items".
④ Recorder output cable
• 5m（Part No. RE-65374）
• 10m（Part No. RE-65375）
• 15m（Part No. RE-65376）
• 20m（Part No. RE-65377）
• Optional length （Part No. RE-65378）
⑤ RS-232C cable
• 15m
D-sub 9pin (Part No. RE-65330) D-sub 25pin (Part No. RE-5677)
• 1 to 15m
D-sub 9pin (Part No. RE-65331) D-sub 25pin (Part No. RE-5647)
⑥ Stand (Part No. RE-8607) for mounting the main unit and the AD-32 (AD-33 or AD-34)
• Stand
• Hexagonal-head bolts (M6×10)8
• Spring washers ....................... 8
• Washers.................................. 8
(2) Unpacking
① Unpack the main unit and confirm that there is no external damage.
② Confirm that all parts of the main unit, accessories, and any optional units as
described in section "(1)Configuration" (C page 9) are included.
To Next Page
Loading...
Need help?
General
