Appendix E: Radio frequency (RF)
safety compliance
When operated in accordance with manufacturer
specifications and AT&T’s instructions, the MetroCell
meets FCC Radio Frequency (RF) safety compliance
requirements. Details are provided below and at
att.com/metrocell.
The terms and conditions agreed to by every customer
purchasing a MetroCell from AT&T require that the
customer take the following actions to avoid excess RF
exposure to employees, contract workers, and other
persons who may gain proximity to the MetroCell antennas
(“Persons with Access”):
a. Install the MetroCell antennas at a distance of at least 1
foot away from any work station or other area where
Persons with Access may routinely be present (i.e. for a
time period greater than one minute), including areas
of short-term duration such as, but not limited to, areas
where there is a light, light switch, thermostat, HVAC unit
or vent, electrical outlet, or sign.
b. Instruct all Persons with Access to remain at least 1 foot
from the MetroCell antennas;
c. Instruct all Persons with Access to inform customer
if there is a need to get closer than 1 foot from the
MetroCell antennas;
d. Instruct all Persons with Access to coordinate work near
the MetroCell antennas with customer;
e. Deactivate the system or MetroCells when needed, in
the manner instructed by AT&T or the Manufacturer, if
Persons with Access need to work near the MetroCell
antennas. When deactivation is required, Customer
will notify the Persons with Access when the system or
MetroCells are deactivated, ensure that the system or
MetroCells remain deactivated while work is performed,
and reactivate the system or MetroCells when all work is
complete and all Persons with Access are located at least
the required distance away from the MetroCells; and
f. Follow such other instructions as AT&T or the
Manufacturer may deem appropriate from time to
time, including, but not limited to, the installation and
maintenance of any notice, caution, and warning signs,
and any RF transparent screen/shield. Customer should
specifically refer to Appendix F to this Installation Guide,
which contains specific instructions for maintaining a
record identifying AT&T as the custodian of the station’s
license to operate.
Definition of small cells included in this certification
This certification covers only a single Alcatel-Lucent 9364
Metro Cell Outdoor V 2.0 antenna when deployed inside a
building, which transmits in only a single frequency band,
either 869-894 MHz or 1930-1990 MHz, at a peak EIRP
of 250 mW. [Note: the 9363 Indoor version covered by
this User Guide uses the same radio as the 9364 Outdoor
model.] Sporton International, Inc., RF Exposure Evaluation
Report FA170613 (27 March 2012 Rev 01), provides
additional details for the small cell and the specifications
used in evaluating compliance. If any RF modifications are
made, AT&T must also reassess the technical parameters
of the small cells identified above to confirm continued
compliance with the FCC exposure limits.
Date of certification: 27 February 2013
Appendix F: Station Authorization
When operated in accordance with manufacturer
specifications and AT&T’s instructions, the MetroCell
meets FCC Radio Frequency (RF) safety compliance.
STATION NAME:
________________________________________
PURSUANT TO FCC RULE 22.303 AND 101.215,
THE CUSTODIAN OF THIS STATION’S LICENSE IS:
AT&T
ATTN: FCC-FAA REGULATORY COMPLIANCE TEAM
3300 E. RENNER ROAD, B3132
RICHARDSON, TEXAS 75082
855-699-7073
Warranty
One-Year Limited Warranty AT&T warrants to the first retail purchaser
of an AT&T MetroCell device that, should this product or any part be
proved defective in materials or workmanship, from date of purchase,
as evidenced by AT&T billing records for a period of one (1) year, then
it will be subject to the terms of this one-year limited warranty. Such
defects will be repaired or replaced without charge for parts or labor
directly related to the defect.
Limitations And Exclusions: This warranty does not apply to any cost
incurred for removal or reinstallation, or to any product or part thereof
which has suffered through normal wear and tear, alteration, improper
installation, physical abuse, misuse, neglect or accident. Damage
resulting from an act of God, including but not limited to fire, flood,
earthquake and other natural disasters will be excluded. This limited
warranty is in lieu of all other warranties, express or implied either in
fact or by operations of law, statutory or otherwise, including, but
not limited to, any implied warranty of merchantability or fitness for a
particular use. AT&T does not authorize any other person to assume
any liability beyond the warranty herein described. In no event, whether
based in contract, tort or any other legal theory, shall AT&T or any of
its agents or sellers be liable for incidental, consequential, indirect,
special, or punitive damages of any kind resulting from the use of this
product, including but not limited to interrupted or incomplete phone
calls, omission or negligence arising out of any breach of this warranty.
In no event shall AT&T or its agents or sellers be liable for any damages
however defined in an amount in excess of the purchase price.
Customers who believe they require warranty service should call the
AT&T Product Management Center at 877-996-7017 and enter the PIN
‘METRO’ (63876). A Customer Care representative will take information
over the phone to attempt to diagnose and remedy the issue. If the
Customer Care representative determines that warranty service is
required, the representative will provide instructions on how to return
the device for repair or replacement.
12 AT&T MetroCell Installation Guide • February 2016
©2016 AT&T Intellectual Property. All rights reserved. AT&T and Globe logo are registered trademarks of AT&T Intellectual Property. All other marks are the property of their respective owners.
To Previous Page
Loading...
