Answering system
77
Answering system settings
Number of rings
You can set the answering system to answer an incoming call after
two, three, four, five or six rings. You can also select toll saver. If
toll saver is selected, the answering system answers a call after two
rings when you have new messages, and after four rings when there
are no new messages. This feature allows you to check for new
messages and avoid paying long distance charges when calling from
out of your local area. By default, the answering system answers an
incoming call after four rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/
SELECT to enter the main menu.
2. Press CID or DIR to scroll to Answering sys,
then press
MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup,
then press MENU/SELECT.
4. Press CID or DIR to scroll to
#
of rings, then
press
MENU/SELECT.
5. Press CID or DIR to choose among 2, 3, 4, 5,
6 or Toll saver.
6. Press MENU/SELECT to save the setting. You hear a confirmation
tone.
NOTES:
If you subscribe to voicemail service through your telephone service provider, see
Answering system and voicemail indicators on page 81.
If you set the number of rings for the answering system as two or three rings, the
caller ID announce feature may not have enough time to announce the caller’s full
information.
•
•
Call screening
># of rings
# OF RINGS
>4
To Next Page
Loading...
Need help?
General
