Answering system
Remote access
You can reach your answering system remotely by dialing your home
telephone number from any touch-tone telephone.
To remotely reach your answering system:
1. Dial your telephone number from any touch-tone telephone.
2. When the system answers, enter the two-digit remote access code (19 is
the default code. See page 59 to change it).
The system automatically announces the number of new or old
messages (if any), and then begins to play them.
3. You can also enter the following remote commands:
Remote
commands
Actions
1
Press to listen to all messages.
2
Press to listen to new messages only.
3
Press to delete the current message
(during playback).
33
Press twice to delete all old messages.
4
Press to repeat the current message
(during playback).
5
Press to stop any operation (including recording).
*
5
Press to listen to a list of remote commands.
6
Press to skip to the next message (during playback).
*
7
Press to record a new announcement.
8
Press to end remote access
(the call will be terminated).
0
Press to turn the answering system on or off.
4. Hang up or press 8 to end the calls.
•
71
To Next Page
Loading...
Need help?
General
