Registration and deregistration
11
Register a handset to your telephone base for AT&T models
CL84115/CL84215/CL84265/CL84365
1. Before you begin registration, put the handset near the telephone
base. Make sure the handset is out of the charger and shows
To register HS, see manual.
2. On the telephone base, press MENU/SELECT in idle mode.
3. On the telephone base, press qCID or pDIR to scroll to
Settings, then press MENU/SELECT.
4. Press qCID or pDIR to scroll to Registration, then press
MENU/SELECT.
5. Press # (pound key) on the handset. Both the handset and the
telephone base show Registering... Please wait and the IN USE
light turns on.
6. Aer a while, both the handset and the telephone base beep
and the IN USE light turns o. The handset displays HANDSET
X Registered (X represents the registered handset number).
The handset is now registered with the telephone base.
If the registration fails, the system will automatically try to register
again. If registration fails aer the third try, Registration Failed
appears on both screens before returning to idle mode. This may
take up to ve minutes to occur. Please start again from Step 1.
NOTES:
You cannot register a handset if any other system handset is in use.
If you try to register more than 12 handsets to the telephone base, the telephone
base shows Registration slots are full and sounds two beeps.
•
•
Adding and registering handsets
To Next Page
Loading...
Need help?
General
