Adding and registering handsets
Before using a new CLP99003 handset, make sure it is registered
with an AT&T CLP99183/CLP99283/CLP99353/CLP99383/
CLP99453/CLP99483/CLP99553/CLP99583 telephone system
(purchased separately). These telephone systems can support up to
12 handsets.
The handset(s) provided with your telephone system are already
registered as HANDSET 1, and so forth. Additional handsets are
assigned numbers in the sequential order they are registered
(up to HANDSET 12). Each handset must be registered to the
telephone base before use.
Register a handset to your telephone base
1. Before you begin registration, make sure the handset is out of
the telephone base or charger and shows To register HS,
see manual.
2. Put the handset you wish to register on the telephone base cradle.
Registration and deregistration
9
For registration, put the handset on the
telephone base, not the handset charger.
3. The handset shows Registering... Please wait. If the registration
is successful, both the handset and the telephone base screens
display HANDSET X Registered ((HANDSET represents the
handset name, X represents the handset number). Both the
handset and the telephone base beep. The handset is now
registered with the telephone base.
To Next Page
Loading...
Need help?
General
