Battery installation and charging
Getting started
7
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert the
supplied battery with
the label THIS SIDE UP
Step 2
Align the cover
flat against
the battery
compartment,
then slide it
upwards until it
clicks into place.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The CHARGE light on the
handset is on during charging.
CHARGE light
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement battery
(model BT183342). To order, visit our website at
www.telephones.att.com or call 1 (800) 222-3111.
In Canada, dial
1 (866) 288-4268.
If you do not use the handset for a long time, disconnect and remove
the battery to prevent possible leakage.
•
•
Battery Pack
BT183342 2.4V 400mAh Ni-MH
WARNING: DO NOT BURN OR
PUNCTURE BATTERIES
MADE IN CHINA
MANUFACTURED BY BYD BYYYWW
To Next Page
Loading...
