Getting started
3
Telephone base and charger installation
Install the telephone base and charger, as shown below.
Charger installation
Telephone base installation
Raise the antenna.•
Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
•
Route the power
adapter cord and the
telephone line cord
through this slot.
•
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of
the telephone base.
•
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
•
Plug the other end
of the telephone
line cord into a
telephone jack or
a DSL filter.
•
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL filter must be
plugged into the telephone
wall jack.
Telephone line cord
IMPORTANT INFORMATION
1.
Use only the power adapter(s) supplied with this
product. To order a replacement power adapter, visit
our website at www.telephones.att.com or
call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
For more detailed instructions,
refer to the online Complete user’s manual at
www.telephones.att.com/manuals.
2. The power adapters are intended to be correctly oriented
in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
Plug the power adapter into a power
outlet not controlled by a wall switch.
To Next Page
Loading...
