AT&T DAL75111 - Record Your Own Announcement; Number of Rings; Ringer Volume

13
Record your own announcement
Your outgoing announcement plays when calls are answered by the answering
system. You can use the preset announcement to answer calls, or replace it with
your own recorded announcement.
Using a cordless handset:
1. MENU -> / -> Answering sys -> SELECT.
2. SELECT to select Announcement.
3. Press 7 to record.
4. Speak towards the handset to record your announcement and press 5 to end
recording and save it.
Number of rings
You can set the answering system to answer an incoming call aer 2, 3, 4, 5, or 6
rings. You can also select toll saver. If you choose toll saver, the answering system
answers a call aer two rings when you have new messages, or aer four rings
when there are no new messages. This enables you to check for new messages and
avoid paying unnecessary long distance charges if you are calling from out of your
local area.
Using a cordless handset:
1. MENU -> / -> Answering sys -> SELECT.
2. / -> Ans sys setup -> SELECT.
3. / -> # of rings -> SELECT.
4. / to choose among 2, 3, 4, 5, 6, or Toll saver -> SELECT.
Ringer volume
You can set the ringer volume level to one of the six levels, or turn the ringer o, for
incoming home or cell calls.
Using a cordless handset:
Set ringer volume for incoming home calls:
1. MENU -> / -> Ringers -> SELECT.
2. SELECT to select Home volume.
3. / to choose the desire level -> SELECT.
Set ringer volume for incoming cell calls:
1. MENU -> / -> Ringers -> SELECT.
2. / to to select Cell volume -> SELECT.
3. / to choose the desire level -> SELECT.
Initial basic settings