AT&T DL72119 - Number of Rings; Remote Access Code

75
Answering system
Answering system settings
Number of rings
Youcansettheansweringsystemtoansweranincomingcallaertwo,three,
four,ve,orsixrings.Youcanalsoselecttollsaver,whichisexplainedbelow.By
default,theansweringsystemanswersanincomingcallaerfourrings.
To set the number of rings:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT.
3. Press CID or DIR to highlight Ans sys setup, then press MENU/SELECT.
4. Press CID or DIR to highlight # of rings, then press MENU/SELECT.
5. Press CID or DIR to choose from 6, 5, 4, 3, 2 or Toll saver.
 Tollsaver-theansweringsystemanswersacallaertworingswhenyou
havenewmessages,oraerfourringswhenthereisnonewmessage.
This feature allows you to check for new messages and avoid paying long
distance charges when calling from out of your local area.
6. Press MENU/SELECT to save.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access
code is 19.
To change the remote access code:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press MENU/SELECT .
4. Press CID or DIR to highlight Remote code, then press MENU/SELECT .
5. Use the dialing keys to enter a two-digit number.
-OR-
Press CID or DIR to scroll to a desired two-digit number.
6. Press MENU/SELECT toconrm.