11
Basic answering system setup via voice guide
You can follow the voice guide to record your own announcement, set the number
of rings and set the message alert tone.
Using a cordless handset:
1. Press MENU -> / -> Answering sys -> SELECT.
2. / -> Voice guide -> SELECT.
3. Set up the answering system by inputting the designated numbers, as
instructed.
Add a Bluetooth
®
cell phone/headset
Note: Your DL72210/DL72240/DL72310/DL72340/DL72350/DL72510/DL72570/DL72580 is
compatible with Bluetooth version 2.0 or above devices.
To use a Bluetooth enabled cellular phone or headset with your telephone, you
must rst pair and connect your Bluetooth cellular phone or headset with the
telephone base.
Bluetooth wireless technology operates within a short range (up to 30 feet). Keep
the connected device within 15 feet of the telephone base for optimal performance.
To pair and connect a cell phone using the telephone base:
1. Press and hold CELL 1 or CELL 2 for about four seconds until the CELL 1 or
CELL 2 light flashes.
2. Place the cell phone next to the telephone base. Turn on the Bluetooth feature
of your cell phone and search for or add new advices. Once your cell phone nds
your AT&T phone (AT&T DECT 6.0), press the appropriate key on your cell phone
to continue the pairing process.
To pair and connect a headset using a cordless handset:
1. MENU -> / -> Bluetooth -> SELECT.
2. / -> Add BT headset -> SELECT.
3. Set your headset to discoverable mode -> Press SELECT.
Record your own announcement
Your outgoing announcement plays when calls are answered by the answering
system. You can use the preset announcement to answer calls, or replace it with
your own recorded announcement.
Initial basic settings
To Next Page
Loading...
