AT&T DL72240 - Set Date and Time

33
Telephone settings
Handset settings
Set date and time
The answering system announces the day and time of each message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are set
automatically with each incoming call. However, the year must be correct so
that the day of the week can be calculated from the caller ID information.
Aerhandsetregistrationorapowerfailure,thehandsetwillpromptyoutoset
the date and time.
To set the date and time manually:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Set date/time, then
press MENU/SELECT.
3. Enter the month using the dialing keys.
4. Enter the day using the dialing keys.
5. Enter the year using the dialing keys, then press
MENU/SELECT to move on to set the time.
6. Enter the hour using the dialing keys.
7. Enter the minute using the dialing keys.
8. Press CID or DIR to highlight AM or PM, then press
MENU/SELECT to conrm.
Note: If the date and time are not set when a message is recorded, the system
announces, “Time and day not set,” before each message plays.
Set date/time
ECO
Date: MM/DD/YY
ECO
Time: HH:MM - -
ECO