Troubleshooting
Appendix
Out of range OR No pwr at base appears on my cordless handset.
f Ensure you plug the telephone base in properly and the power is
on.
f Place the cordless handset in the telephone base for one minute
to allow the cordless handset and base to synchronize.
f Move the cordless handset closer to the telephone base. You
might have moved out of range.
f Reset the telephone base. Unplug the electrical power. Wait for
15 seconds, then plug it back in. Allow up to one minute for the
cordless handset and telephone base to reset.
f Other electronic products such as HAM radios and other DECT
phones, can cause interference with your cordless phone. Try
installing your phone as far away as possible from these types of
electronic devices.
The batteries do not hold a charge.
f If the handset is in the charger and the charge light does not
turn on, refer to The charge light is o (page 26) in this
Troubleshooting guide.
f Charge the battery in the handset for at least 16 hours. For optimum
daily performance, return the handset to the telephone base or
charger when not in use.
20
My cordless handset isn’t performing normally.
f Make sure you plug the power cord securely into the telephone
base. Plug the power adapter into a dierent, working electrical
outlet without a wall switch.
f Move the cordless handset closer to the telephone base. You
might have moved out of range.
f Reset the telephone base. Unplug the electrical power. Wait for
15 seconds, then plug it back in. Allow up to one minute for the
cordless handset and telephone base to reset.
f Other electronic products such as HAM radios and other DECT
phones, can cause interference with your cordless phone. Try
installing your phone as far away as possible from these types of
electronic devices.
To Next Page
Loading...
Need help?
General
