1
Getting started
Battery installation
Install the battery as shown below. Aer installing the battery,
you may be able to make and receive short calls. For optimal
performance, charge the headset battery for at least six hours
before use. When not in use, recharge the headset by returning it
to the headset base.
NOTE: Remove the earloop from the headset before battery replacement.
1. Insert the battery into the battery
compartment with the label THIS
SIDE UP facing up.
2. Push the battery plug into the
connector inside the compartment
according to the color-coded label
and place the wires neatly inside
the compartment.
3. Insert the tab on the bottom of
the battery cover into the battery
compartment. Press down gently
on the battery cover until it snaps
into place.
1
2
3
Getting started
Battery charging
Aer installing the battery, charge the headset by placing it in
the headset base as shown below. The headset ON/OFF light is
on when the headset is charging.
1. Insert the headset into the
headset base.
2. Push the headset downward
until the ON/OFF light on the
headset turns on.
Insert
Push
ON/OFF light
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or a proper replacement battery.
2
NOTE: It takes 3 to 5 hours for a full charge.
3
marathon_quickstart_04df.indd 3 3/3/2016 2:42:32 PM
To Next Page
Loading...
