Getting started
9
Register a headset to the TL7810/TL7812 headset base
Make sure the battery is properly installed in
the headset (see page 6). The light flashes
slowly in red and blue to indicate the headset
is not registered.
Place the headset in the headset charger and
allow it to charge for at least one hour before
beginning registration.
Remove the headset from the headset charger.
Press and hold the PAIR button on the
headset base that you want to register this
headset to (about four seconds) until the
MUTE light on that headset base turns on and
then release the button.
Return the headset to the headset charger
for registration. The light flashes quickly
in red and blue.
It takes about 60 seconds to complete the
registration process. TheThe light turns red
when the headset is registered but not fully
charged, or turns blue when it is registered
and fully charged.
If the registration fails, you hear the voice prompt "Not
registered" when you press the button on the headset, and the
light on the headset flashes slowly in red and blue.
To reset the headset, remove it from the headset charger and try
the registration process again.
NOTE: You cannot register a headset if another system headset is in use.
1.
2.
3.
4.
5.
Adding and registering headsets
To Next Page
Loading...
