16
Getting started
Headset base installation
Option 3: Connect the headset to your computer (cont.)
After you have installed the AT&T Softphone Call Manager,
check to make sure the audio setting is properly configured
in your Windows system. If you have installed Skype and/or
Microsoft Lync and want to use them with your headset,
make sure the audio settings are configured correctly in the
programs as well.
a) Audio settings in Windows system:
Launch the AT&T Softphone Call Manager program.
Click on the Settings panel, then the General panel.
Click on [Click to launch audio devices control panel].
Make sure AT&T DECT Headset is selected under the
playback and recording settings in your Windows system.
b) Audio settings in Skype:
Launch the Skype program.
Click on Tools, then Options.
Click on Audio settings.
Make sure AT&T DECT Headset is selected under the
speakers and microphone settings.
c) Audio settings in Microsoft Lync:
Launch the Microsoft Lync program.
Click on Options, then Audio device.
Make sure AT&T DECT Headset is selected under the
Audio device setting.
3.
i.
ii.
iii.
iv.
i.
ii.
iii.
iv.
i.
ii.
iii.
IMPORTANT
Periodically check for software updates. Go to the Support panel in
the AT&T Softphone Call Manager, then click on Check now. For
more details, refer to the Installation and Operation Guide for AT&T
Softphone Call Manager.
To Next Page
Loading...
