Appendix
33
Adding and registering headsets
Registration options
The TL7810 headset comes pre-registered to the headset base.
There are two registration options as described below.
Option 1: The TL7810 supports up to two cordless headsets. You
can register a TL7800 (purchased separately) headset
or a previously deregistered TL7810/TL7800 headset
to your TL7810 headset base (see page 34).
Option 2: You can deregister your TL7810 headset (see page
37) and then register it to an AT&T DECT 6.0 cordless
telephone (see pages 35-36). You can register a
maximum of two headsets (TL7810/TL7800) to a
cordless telephone. The telephone base recognizes
and counts a headset the same as a handset. When
you register the headset to an AT&T DECT 6.0 cordless
telephone, the headset base acts only as a charger
for the headset. The CORDED HANDSET CONNECTED
switch, VOLUME and mode controls on the headset
base become inactive. You can place the headset base
anywhere you have an available power outlet. Do not
plug in the telephone line cord; you only need to plug
the headset base into a power outlet.
Refer to your telephone user’s manual for the maximum
number of handsets/headsets that you can register to
the telephone base. If you have the maximum number
of handsets/headsets registered, you need to follow the
deregistration information in your user’s manual. Visit
www.smbtelephones.att.com/
compatibility-finder for a complete list of AT&T
phones that have been tested and found to be
compatible with the TL7810.
You can only register the headset to one product at a time, so
the headset must be deregistered before it can be registered to
a headset base or a cordless telephone (see page 37).
Appendix
To Next Page
Loading...
