Appendix
California Energy Commission battery charging testing
instructions
This telephone is set up to comply with the energy-conserving standards right out of the
box. These instructions are intended for California Energy Commission (CEC) compliance
testing only. When the CEC battery charging testing mode is activated, all telephone
functions, except battery charging, will be disabled.
When first purchased and properly installed for charging (see the Battery installation
and charging section on pages 6-7), put the cordless handset in the handset charger to
charge. The CEC battery charging testing mode is activated while charging.
If you have registered the cordless handset to the TL88102/TL88202 base, refer to the
following testing instructions.
To activate the CEC battery charging testing mode:
1. When the phone is not in use, press MENU, , 2, 3, 2, 7, 3, 8, # and then the left
soft key on the telephone base.
2. The CEC battery charging testing mode will be activated in about 60 seconds. You
hear a confirmation tone from the telephone base.
When the phone successfully enters the CEC battery charging testing mode, all
cordless handsets will be deregistered. All handsets show Press [HOLD] on base
for 4 sec, then press [#] on handset.
When the phone fails to enter this mode, repeat the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See page 8 for handset
registration instructions.
BC
29
To Next Page
Loading...
