7
Battery installation and charging
Install the battery as shown below.
IMPORTANT INFORMATION:
Use only the supplied rechargeable battery or replacement battery (model
BT166342). To order, visit our website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
If you do not use the handset for a long time, disconnect and remove the
battery to prevent possible leakage.
•
•
After you install your telephone or power returns following a
power outage, the handset will prompt you to set the date and
time. For instructions, see Set date and time in the telephone
system user’s manual for details. To skip setting the date and
time, press OFF/CANCEL or BACK.
CHARGE light
Step 3
Charge the handset by placing it
face up in the telephone base or
charger. The CHARGE light is on
when charging.
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment, matching
the color-coded label.
Insert the supplied battery
with the label THIS SIDE
UP facing up as indicated.
Step 2
Align the cover
flat against
the battery
compartment, then
slide it upwards
until it clicks into
place.
SET DATE
--/--/--
MM/DD/YY
BACK
SET
SET TIME
--:-- --
BACK
SET
Getting started
To Next Page
Loading...
Need help?
General
