Add and register handsets
If registration fails, the system will automatically try to register
again. If registration fails aer the third try, Registration failed
appears on both screens. The handset shows To register, see user
manual and the telephone base returns to idle mode. This may
take up to ve minutes to occur. Please start again from Step 1.
Method 2:
1. Press and hold /FIND HS on the telephone base for about four
seconds and it shows Registering... Please wait. Release
/FIND HS.
2. Press QUIET # on the handset. The handset shows Registering...
Please wait. If the registration is successful, both the handset
and the telephone base screens display HANDSET X Registered
(HANDSET represents the handset name, X represents the
handset number). Both the handset and the telephone base
beep. The handset is now registered with the telephone base.
If registration fails, Registration failed appears on both screens.
The handset shows To register, see user manual and the telephone
base returns to idle mode. Please start again from Step 1.
Notes:
f You cannot register a handset if any other system handset is in use.
f If you try to register more than 12 handsets to the telephone base, the telephone base shows
Registration slots are full and sounds two beeps.
Registration and deregistration
11
If it is the rst time you install your AT&T
TL96457/TL96477/TL96487/TL96497/TL96547
telephone system, or power returns following a
power outage, the handset will prompt you to set
the date and time when registration is successful.
Aer that, it will prompt if you want to set up
Smart call blocker* and the answering system via
voice guides. Press YES on the handset to start.
For details, see the corresponding sections in the
telephone system’s user’s manual. To skip these
settings, press OFF/CANCEL on the handset.
Start voice
guide to set
up Answering
system now?
NO
YES
Start voice
guide to set
up Smart call
blocker now?
NO
YES
* Includes licenced Qaltel
TM
technology.
Qaltel
TM
is a trademark of Truecall Group Limited.