AT&T TL96271 - Record your own announcement

22
Answering system settings
Record your own announcement
Using a handset or the telephone base:
Press MENU on the handset in idle mode to enter the
main menu.
Press CID or DIR on the handset, or CID or DIR
on the telephone base to scroll to Answering sys, then
press SELECT .
Press SELECT again to select Announcement.
The screen displays ANNOUNCEMENT. The handset
announces, “Announcement, press PLAY or RECORD.”
Press RECORD .
The telephone announces, “Record after the tone.
Press STOP when you are done.” After the tone,
speak towards the microphone of the handset or
telephone base.
Press STOP when you finish recording.
The telephone automatically plays back the newly
recorded announcement. Press STOP to stop the
playback at any time. After the announcement playback, press PLAY to
replay the recorded announcement, or RECORD to record again if desired.
NOTES:
Your announcement can be up to 90 seconds in length.
Announcements shorter than two seconds are not recorded.
1.
2.
3.
4.
5.
6.
7.
•
•
Recording
announcement...
STOP
Announcement
playback
DELETE STOP
Announcement
playback
DELETE STOP
Recording
announcement...
STOP