AT&T TL96271 User Manual

2
Telephone base installation
Telephone base installation
Install the telephone base and charger as shown below.
Plug one end of the
telephone line cord into
a telephone jack or a DSL
filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Telephone line cord
Route the telephone line
cord through this slot.
Plug the other end of the
telephone line cord into
the telephone jack on the
back of the telephone base.
Plug the small end of the
telephone base power adapter
into the power adapter jack on
the back of the telephone base.
Raise the antenna.
Plug the large end of
the power adapter into a
power outlet not controlled
by a wall switch.
Route the power adapter cord
through this slot.

AT&T TL96271 Specifications

General

Brand	AT&T
Model	TL96271
Category	Cordless Telephone
Language	English