2. When the bulb is in position, replace the lamp housing and firmly screw into place.
3. To alter the angle of the lamps, loosen the black knob on either side of the black mounting
bracket, move the lamp to the required angle, then tighten the two knobs to hold the lamp
securely.
4. To extend tripod: Twist black knobs in counter clockwise direction, extend post to desired
level and re-tighten knob by twisting clockwise. Use only your hand to adjust. Do not use
wrench or pliers.
5. Adjust tripod legs: Loosen knob on top bracket. Slide legs down to desired level and
retighten knob. Put weights on tripod legs if ground is uneven or wind is blowing.
6. When the bulb is in position, replace the lamp housing and firmly screw into place.
Troubleshooting
Symptom Possible Cause Corrective Action
Lamp will not operate
Bulb broken Replace bulb
Poor contact between lamp
and socket
Check to see if lamp is securely
installed into socket
Improper wiring
Have unit checked by a qualified
electrician
Incorrect voltage; voltage at
fixture too high/low
Have power supply checked by a
qualified electrician
To Next Page
Loading...