Need help?Do you have a question about the Ateme Kyrion CM5000 and is the answer not in the manual?
Details the standard I/O ports (AC inlet, Ethernet, ASI, SYNC, ALARM) and their functions.
Describes various optional extended interfaces like L-Band, IF, ASI/SDI, AES, and Analog Audio.
Provides step-by-step instructions for unpacking, installing, and connecting the CM5000 hardware.
Guides through initial configuration steps like IP address setup and basic interface access.
Outlines the three main configuration methods: Front Panel, Web GUI, and SNMP.
Describes the front panel interface including LCD, keypad, and menu navigation for basic operations.
Details how to access, log in, and navigate the web-based graphical user interface.
Covers detailed configuration for channels, including Global, TS, Video, Audio, and Data parameters.
Explains configuration options for the remuxer, such as TS settings, output configurations, and carrier ID.
Details system-wide configurations for Time, Network, Automation, Security, Firmware, and Licenses.
Outlines procedures for firmware updates, backups, and restores.
Provides steps for system recovery and accessing the maintenance menu.
Explains the 1+1 IP redundancy feature for ensuring service continuity.
Illustrates a scenario involving 4k streams, remuxing, and L-Band/IF modulation.
General| Power Supply | 100-240V AC, 50/60Hz |
|---|---|
| Audio Encoding | AAC, MPEG-1 Layer II, Dolby Digital |
| Video Input | SDI, HDMI |
| Video Output | SDI, HDMI |
| Audio Input | Embedded, AES/EBU |
| Audio Output | Embedded, AES/EBU |
| Compression Standards | MPEG-2, H.264, HEVC |
| Latency | Low latency mode available |
| Network Interface | Gigabit Ethernet |
| Video Decoding | H.264/AVC, H.265/HEVC, MPEG-2 |
| Video Encoding | MPEG-2, H.264, HEVC |
| Audio Decoding | MPEG-1 Layer II, Dolby Digital |
| Supported Resolutions | SD, HD |
To Next Page