ATEMPOWER AP20DC - Troubleshooting; Technical Specifications

TECHNICAL SPECIFICATIONS
Type
Model:
Input
Output / Charging Voltage
Minimum Start Voltage
Soft Start
Soft Charge Current
Bulk Charge Voltage
Absorption
Equalisation
Float Charge Voltage
Float Charge Current
Battery Range
0 - 1 Metres
5 Metres +
AP20DC
Multi Stage
DC Battery:13.0 -16.0 Volts
Solar Input:16.0 - 25.0 Volts
14.4 - 15.4 Volts ( Stops charging when vehicle battery below 12.5V without
ACC line connected/below 10.8V with ACC line connected )
2.5 Volts - For battery being charged
YES
14.7V (AGM/Gel)14.4(Lead Acid)15.4(Calcium)14.4V(LiFePO4)
Constant voltage with automatic amperage control
Automatic
13.5 (AGM/Gel)13.5V(Lead Acid)13.5V(Calcium)
0-20A
60 to 600Ah
10AWG
8 AWG
6 AWG
DC Output:20A Solar Output:20A
Charge Control
1 - 5 Metres
Cable Length / Twin Core
TROUBLESHOOTING
20A
6
Display shows that the charger is not charging: check where the battery is connected; check the
terminals; check whether the battery is 12V.
Battery is not charging: check whether all connections are connected correctly; check the status of
the battery; check the status of your vehicle or solar panel.
Battery cannot be fully charged or power cannot be maintained: please check whether your battery
has been used for over 3 years; overheat; low in electrolyte; over-charging or battery vulcanized; You
need to consult your battery manufacturer to check its condition or make a replacement.
Output Current