UNPLUGGING IT
Before you pull out the cable, turn the key to the
ON position to unlock the connector.
Keep the key in the ON position and wait for 5
seconds.
Remove the charging connector, and put it back
in the Ather Dot
TM
holder. Remember to close the
charging port flap on the scooter.
You can check the charge status on the dashboard
while it’s charging. You can also check it on your
phone, by using Ather App
TM
.
CAUTION
Do not leave the connector on the ground to avoid
damage through dust and water ingress.
Do not try to forcefully pull the connector out. Try
turning the key to OFF, back to ON and try again. It
should come out eortlessly.
Disclaimer: Remote charge status on the Ather App
TM
is available only
with the Pro.
Charge it up
34
1
2
3
To Next Page
Loading...
