Plug in the other end of the cable to the scooter’s
charging port. Turn the key to OFF position and pull
it out. To plug out, keep the key in the ON position,
wait for 5 seconds, then remove the charging
connector and close the charging port flap.
CAUTION
Remove the key once your scooter is connected to
the charger or disconnected from the charging
cable. Do not turn the key ON and pull out the
connector at the same time. Hold on for 5 seconds
to pull the connector out. Do not remove the
connector while your scooter is charging. You run
the risk of damaging the connector and/or the
scooter.
Charge it up
36
To Next Page
Loading...
