WWW.ATKBINDINGS.COM | PROUDLY MADE IN ITALY SINCE 2007 27
WARNING! DANGER!
These bindings and the connected accessories can be exclusively installed, adjusted or calibrated by a
“SPECIALIZED TECHNICIAN”
A “SPECIALIZED TECHNICIAN” is any technician operating in the ski/ski touring business field provided with
the following minimum requirements:
1) Is in possession of the original ATK® “AUTOMATIC DRILLING JIG” addressed to the installation of the
product and has perfectly understood the entirety of the respective guidebooks. (WARNING! The
Specialized Technicians shall be in possession of the latest release of the Drilling Jig Guidebook, which
can be found at the ATK web page : https://www.atkbindings.com/it/downloads-eng/).
2) Is in possession of the experience, know-how and skills raising from years of practice in the field of
“TECH” bindings installations, adjustment and calibration.
3) Is in possession of the whole instruments and tools needed to perform a perfect installations,
adjustment and calibration of an ATK® ski touring “TECH” binding, including the specific testing
machinery needed to check the real and correct release performance of the binding.
The “SPECIALIZED TECHNICIAN” shall:
1) Perfectly install, adjust and calibrate the product and its
accessories.
2) Deliver the product to the “Original User” including the
“SEAL OF LIABILITY”, still complete and correctly applied
to the product.
3) Check that the “WARNING STICKER” is properly applied to
one of the two skis in front of the toe piece area.
4) Deliver this “INSTALLATION, USE and MAINTENANCE
GUIDEBOOK” to the “Original User”.
The installation, adjustment and calibration of an ATK® binding is strictly forbidden to any technician that
does not meet the whole 3 above mentioned minimum requirements, because of the greater risks raising
from a wrong installation, adjustment and calibration.
To Next Page
Loading...