Atlanta EVA - Page 20

Rev.0 13/01/2020
Operator Panel | TURNTABLE - MAST
16
Eva Synthesi Mytho
X X
F30 Upward cycle in steps of the roll holder carriage; 0 = disabled
X X
F31 Number of step revs ( F30 )
OPT OPT
F32 Film tension on the product during the step cycle rotations
OPT OPT
F33 Only PS (MPS2) carriage: lengthening of the film during the
step cycle rotations
OPT OPT
F34 Number of initial creasing rotations at the base of the product
(after F05 rotations with film open); if = 0 do not perform
creasing at the base
OPT OPT
F35 0 : creasing in ascent disabled
1 : creasing complete in ascent
(Opt: advanced creasing) 2 : creasing from low rotations up to
the reinforcement (excluded)
(Opt: advanced creasing) 3 : creasing from the reinforcement
(included) at high rotations
(Opt: advanced creasing) 4 : creasing only during reinforcement
OPT OPT
F36 Number of creasing rotations at the top of the product
(Opt: advanced creasing) before performing the creasing
rotations, raise F63 cm; if F36 = 0 , do not perform creasing at
high rotations
OPT OPT
F37 0 : creasing in descent disabled
1 : creasing complete in descent
(Opt: advanced creasing) 2 : creasing from the reinforcement
(included) at low rotations
(Opt: advanced creasing) 3 : creasing from high rotations up to
the reinforcement (excluded)
OPT OPT
F38 Number of final rotations at the base of the product; if F38 =
0 , do not perform creasing
OPT OPT
F39 Crease closing adjustment time (permits wrapping with
partially closed film)