To Next PageTo Next Page
Need help?Do you have a question about the Atlantic VM 80 N4C and is the answer not in the manual?
General| Type | Electric Water Heater |
|---|---|
| Capacity | 80 liters |
| Diameter | 433 mm |
| Weight | 21 kg |
| Energy Class | C |
| Vertical | Yes |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Thermal Insulation | Polyurethane Foam |
| Heating Element | Copper |
| Protection | IP 24 |
Device not for persons with disabilities or lack of experience unless supervised. Children must be supervised.
Handle with care, ensure wall support, provide ventilation, avoid bathroom zones, leave space for element replacement, switch off power before access.
Install bipolar cut-out, safety device, use proper pipes, ensure earth connection, and regularly discharge safety device.
Procedure for draining the unit. Device compliance with directives. Note for under-sink models.
Do not dispose in garbage; recycle. Instruction book available via after-sales service.
Refer to diagrams for installation. Ensure space for element replacement. Consider vertical/horizontal mounting.
Clean pipes, avoid brass fittings. Install safety device per standards. Use pressure reducer if water pressure exceeds 0.5 MPa.
Details for pressurised system installation and unpressurised system with special mixer tap. Note on dripping water.
Connect to AC 230V with rigid cable. Use appropriate channeling. Ensure proper earthing and bipolar cut-out device.
Direct connection prohibited in France. Thermal circuit breaker with manual reset for overheating protection.
Never power up without water. Fill tank, bleed air, check leaks. Be aware of normal sounds and safety alerts.
Operate safety device monthly. Professional servicing includes descaling, anode replacement, and part checks.
Procedure for draining the unit. Advice for hard water areas and for extended absences.
Warranty valid if installed per manual. Covers defects, excludes wear parts. Contact installer or dealer for claims.
