Atlas Copco ACTA 4000 - Page 129

ACTA 4000 User Guide Technical specifications
9836 4171 01 2008-12 129 (136)
Q.prog selection No controller Other
controller
F2000/PF2000
Manual input
F2000/PF2000
RS232
DS/DL
Manual input
Parameter 2
None (If
transducer has an
angle encoder:
Angle)
None (If
transducer has an
angle encoder:
Angle)
None (If transducer
has an angle
encoder: Angle)
None (If transducer
has an angle encoder:
Angle)
None
Statistical
parameter 2
None (If
transducer has an
angle encoder:
Mean, σ)
None (If
transducer has an
angle encoder:
Contr, Diff)
None (If transducer
has an angle
encoder: Contr,
Diff)
None (If transducer
has an angle encoder:
Contr, Diff)
None
Comments row 1
Comments row 2
TCT = Transducer Calibration Torque, TTS = Transducer Torque Span
Q.prog selection DS/DL RS232 PF3000/PF4000
Manual input
PF3000/PF4000
RS232
PowerMACS
Manual input
PowerMACS
RS232
Target torque
Read from
controller
0.75 * TCT * TTS Read from
controller
0.75 * TCT * TTS Read from
controller
Calibration torque
0.75 * TCT *
TTS
0.75 * TCT * TTS Read from
controller
0.75 * TCT * TTS Read from
controller
Parameter set
Read from
controller
0 Read from
controller
0 Read from
controller
Controller
DS/DL PF3000/PF4000 PF3000/PF4000 PowerMACS PowerMACS
Communication
Infrared or
RS232
Manual input RS232 Manual input RS232
Cell ID
0 0 0 0 0
Channel
1 1 1 1 1
Model
Tensor S Tensor S Read from
controller
Tensor S Tensor S
Filter frequency
500 Hz 500 Hz 500 Hz 500 Hz 500 Hz
Rotation direction
CW CW CW CW CW
Measure strategy
Peak Peak Peak Peak Peak
Cycle start
0.05 * TCT 0.05 * TCT Read from
controller
0.05 * TCT Read from
controller
Cycle complete
0.10 * TCT 0.10 * TCT Read from
controller
0.10 * TCT Read from
controller
Start angle
0.12 * TCT 0.12 * TCT Read from
controller
0.12 * TCT Read from
controller
Angle complete
Peak torque Peak torque Read from
controller
Peak torque Read from
controller
Measure delay time
0 ms 0 ms 0 ms 0 ms 0
Reset time
0 ms 0 ms 0 ms 0 ms 0
End time
400 ms 400 ms Read from
controller
400 ms Read from
controller