Need help?Do you have a question about the Atlas Copco ACTA 3000 and is the answer not in the manual?
General| Brand | Atlas Copco |
|---|---|
| Model | ACTA 3000 |
| Category | Measuring Instruments |
| Language | English |
Overview of ACTA's available versions and core features.
Explains how to use ACTA with supported hardware and software.
Describes the ACTA 4000/3000 front panel layout and components.
Details the ACTA display, including its size and power-save function.
Explains how to access and enter data in input dialog boxes.
Provides recommendations for installing and setting up the ACTA unit.
Describes the startup sequence and self-test procedure for ACTA.
Explains how to use the Quick Programming function for measurements.
Allows switching between different Measurement dialog boxes based on ACTA version.
Overview of the Q.Prog menu structure and options.
How ACTA saves and provides statistics on tightening operations.
Customizing ACTA parameters to match demands and requirements.
Defines parameters like Peak Value, Installed Torque, and Filter Frequency.
Lists and explains various available measuring strategies.
Default measure strategy for peak torque in direct driven tools.
Common parameters displayed in result dialog boxes like battery and communication symbols.
Details the Basic, Custom, and Trace dialog boxes available by ACTA version.
Checks and provides statistical status after a specified number of measurements (batch).
Controlling how well a tool or controller-tool combination corresponds to a transducer.
Using dead-weight equipment to calibrate transducers with ACTA.
Procedures for calibrating ACTA, requiring a certified laboratory.
Displays a continuous report of tightening operations for tools.
Presents a rundown report detailing tightening operations and statistics.
Report detailing the setup parameters for a specific tool.
Defines key statistical parameters like xi, n, X-bar, and sigma.
Explains SPC and control charts for spotting deviations from normal distribution.
Indicates how well a process performs within tolerance limits using CM and CMK.
Details the connectors on the back panel of the ACTA 4000.
Default settings for ACTA and Q-prog configurations.
Setup options for Q-prog synchronize with various controllers.
Instructions on how to clean the ACTA unit safely.
Recommendations for ACTA calibration and service.
Information on how to upgrade the ACTA software.
To Next Page
