ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 69 (136)
4.8.4 Parameter
This pull-up menu will let you select desired graph parameters. They are used when displaying graphs in
the trace measure dialog. When selecting a graph mode parameter, ACTA uses this selection as standard
until another graph mode parameter setting is performed. The modes available are:
Menu item Description
1 Torque(angle)
Torque over angle
2 Torque(time)
Torque over time
3 Angle(time)
Angle over time
4 Torque, angle(time)
Torque and angle over time
Angle scale is only available when transducer with angle encoder has been used
during the tightening process.
To Next Page
Loading...
