ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 65 (136)
values.
6 Result UCLr
Here is where you define the upper control limit for each subgroup range
values.
7 Result CM >
Here is where you define the minimum allowed CM value. Values below
this minimum value will initiate statistical alarms.
8 Result CMK >
Here is where you define the minimum allowed CMK value. Values
below this minimum value will initiate statistical alarms.
9 Result CAM >
Here is where you define the minimum allowed CAM value. Values
below this minimum value will initiate statistical alarms.
When all parameters have been set according to your preference, highlight
OK and press Enter or simply
press the
OK button on the keypad.
4.7.6 Display setup
The ACTA QC and AA have a custom measurement display dialog box which is selected under the View
menu block. This dialog box is customized under the
Display setup.
The custom measurement display of ACTA QC and AA is individual for each tool.
You choose to display for each tool what is interesting to see for this specific tool.
The parameters and their effect in the custom measurement dialog are presented below.
1 Parameter 1
This parameter is shown in the top left part of ACTA custom
measurement display. Here you set which value to be shown as
parameter 1.
1 None
The field remains empty
2 Torque
Torque is displayed
3 Angle
Angle is displayed
4 Pulses
Number of pulses is displayed
5 C torque
Controller torque value
6 C angle
Controller angle value
To Next Page
Loading...
