Programming ACTA ACTA 4000 User Guide
52 (136) 2008-12 9836 4171 01
When an Atlas Copco transducer with memory is connected to ACTA, a check of the
next calibration date is performed:
If there are less than 30 days to the next calibration date, a message dialog box
appears telling the operator that the transducer needs to be calibrated before the next
calibration date.
If the next calibration date has passed, a message dialog box appears telling the
operator that the transducer needs to be calibrated. Contact your Atlas Copco service
representative to recalibrate and reset the transducer.
4.5.5 Communication
In this pull-up menu choice of communication is made. From here you can also control ACTA 4000 when
performing automatic calibration.
1 Controller
Sets up for communication with a controller.
2 ToolsTalk QAT
Sets up for communication with ToolsTalk QAT.
3 Barcode
Sets up for communication with a barcode reader.
4 Start Tightening
Used in automatic calibration when ACTA controls tightening operations.
Performs tightening. See below for more information.
5 Start Batch
Used in automatic calibration when ACTA controls tightening operations.
Performs complete tightening batch. See below for more information.
6 Reverse
Used in automatic calibration when ACTA controls tightening operations.
Reverses tightening by 90۫. See below for more information.
Start tightening, Start Batch and Reverse
This function is only available for fixtured applications.
ACTA can be used to carry out an automatic calibration of the Atlas Copco PowerMACS and Power
Focus 3000/PF4000.The user just sets up the appropriate parameters and lets ACTA do the job. The Start
batch, start tightening and reverse functions are used when performing such a calibration. These menu
entries are only visible when ACTA is set up for such an automatic calibration See Automatic tool
calibration for instructions.
To Next Page
Loading...
