Measurement results ACTA 4000 User Guide
86 (136) 2008-12 9836 4171 01
6.4 Zone result window
When a zone is finished, the zone result window will pop up if the zone result is turned on in the
tightening interface dialog
(Conf > Interface > Tightening). The zone result is OK if all batches and
tightening within the zone are OK.
The result soft key shows a listing of all tools in the zone.
This window is a chain of windows scrolled in by using the
right- and left arrow soft keys as below.
Each window lists results for the tools for zone. Select a tool and press
ENTER to access the Statistics
torque-, Statistics angle- and Statistics pulse windows for each tool.
Zone result torque Zone Result angle
Zone result n pulses
To Next Page
Loading...
