ACTA 4000 User Guide Measurement results
9836 4171 01 2008-12 85 (136)
Within Limits
If results are within limits, this window will pop up on
your ACTA QC or AA after you have completed your
specified batch. If there is no angle encoder in the
transducer, no angle information will be given.
Outside Limits
If any result is outside the limits, this window will pop
up on your ACTA QC or AA after you have completed
your specified batch.
The menu blocks:
Menu item Description
Torque
Selecting this opens the Statistics torque dialog box normally accessed
from menu block
Stat>Statistics torque
Angle
Selecting this opens the Statistics angle dialog box normally accessed
from menu block
Stat>Statistics angle
Cancel
This closes the batch result window
Pulse
Selecting this opens the Statistics pulses dialog box normally accessed
from menu block
Stat>Statistics pulses
Cal
Selecting this opens the Non controlled tool calibration dialog box
normally accessed from menu block
Conf>Calibration>Tool
To Next Page
Loading...
